BETA

13 Amendments of Kateřina KONEČNÁ related to 2018/0070(COD)

Amendment 23 #
Proposal for a regulation
Recital 19
(19) Since public awareness of the hazards that POPs pose to the health of present and future generations as well as to the environment, particularly in developing countries, is often lacking, wide-scale information is needed to increase the level of caution and public understanding of the rationalegain support for restrictions and bans. In accordance with the Convention, public awareness programmes on those substances, on their health and environmental effects and on their alternatives, especially for the most vulnerable groups, as well as training of workers, scientists, educators, technical and managerial personnel should be promoted and facilitated, as appropriate. The Union should ensure access to information and public participation, implementing the UN/ECE Convention on access to information, public participation in decision making and access to justice in environmental matters (Aarhus Convention),which was approved by the Union on 17 February20051a. _________________ 1a OJ L 124, 17.5.2005, p. 1.
2018/08/10
Committee: ENVI
Amendment 30 #
Proposal for a regulation
Article 6 – paragraph 1
1. Within two years of the date of entry into force of this Regulation or Regulation (EC) No 850/2004, whichever date came first , Member States shall draw up inventories for the substances listed in Annex III released into air, water and land or contained in waste, in accordance with their obligations under the Convention and the Protocol, and shall subsequently maintain suchupdate those inventories .
2018/08/10
Committee: ENVI
Amendment 31 #
Proposal for a regulation
Article 6 – paragraph 3
3. Member States shall, when considering proposals to construct new facilities or to significantly modify existing facilities using processes that release chemicals listed in Annex III, give priority consideration to alternative processes, techniques or practices29a that have similar usefulness but which avoid the formation and release of substances listed in Annex III, without prejudice to Directive 2010/75/EU of the European Parliament and of the Council30. _________________ 29aStockholm Convention on POPs (2008). Guidelines on Best Available Techniques and Provisional Guidance on Best Environmental Practices Relevant to Article 5 and Annex C of the Stockholm Convention on Persistent Organic Pollutants. Geneva, Secretariat of the Stockholm Convention on POPs. http://www.pops.int/Implementation/BAT andBEP/BATBEPGuidelinesArticle5/tabi d/187/Default.aspx 30 Directive 2010/75/EU of the European Parliament and of the Council of 24 November 2010 on industrial emissions (integrated pollution prevention and control) (OJ L 334, 17.12.2010, p. 17).
2018/08/10
Committee: ENVI
Amendment 36 #
Proposal for a regulation
Article 11 – paragraph 3
3. Without prejudice to Directive 2003/4/EC of the European Parliament and of the Council32 , information referred to in paragraphs 1 and 2on health and safety of humans and the environment shall not be regarded as confidential. The Commission, the Agency and the Member States that exchange other information with a third country shall protect any confidential information in accordance with Union law as mutually agreed.. _________________ 32 Directive 2003/4/EC of the European Parliament and of the Council of 28 January 2003 on public access to environmental information and repealing Council Directive 90/313/EEC (OJ L 41, 14.2.2003, p. 26).
2018/08/10
Committee: ENVI
Amendment 41 #
Proposal for a regulation
Article 13 – paragraph 1 – subparagraph 2 a (new)
The Union shall ensure access to information and public participation throughout the monitoring of implementation.
2018/08/10
Committee: ENVI
Amendment 46 #
Proposal for a regulation
Annex I – part A – table – column 4 – row 1 – point 2 – point a
(a) without prejudice to subparagraph (b), articles and mixtures containing concentrations below 0,1 % of tetrabromodiphenyl ether by weight when produced partially or fully from recycled materials or materials from waste prepared for re-use;deleted
2018/08/10
Committee: ENVI
Amendment 47 #
Proposal for a regulation
Annex I – part A – table – column 4 – row 2 – point 2 – point a
(a) without prejudice to subparagraph (b), articles and mixtures containing concentrations below 0,1 % of tetrabromodiphenyl ether by weight when produced partially or fully from recycled materials or materials from waste prepared for re-use;deleted
2018/08/10
Committee: ENVI
Amendment 48 #
Proposal for a regulation
Annex I – part A – table – column 4 – row 3 – point 2 – point a
(a) without prejudice to subparagraph (b), articles and mixtures containing concentrations below 0,1 % of hexabromobiphenyl ether by weight when produced partially or fully from recycled materials or materials from waste prepared for re-use;deleted
2018/08/10
Committee: ENVI
Amendment 49 #
Proposal for a regulation
Annex I – part A – table – column 4 – row 4 – point 2 – point a
(a) without prejudice to subparagraph (b), articles and mixtures containing concentrations below 0,1 % of heptabromodiphenyl ether by weight when produced partially or fully from recycled materials or materials from waste prepared for re-use;deleted
2018/08/10
Committee: ENVI
Amendment 52 #
Proposal for a regulation
Annex I – part A – row 24 a (new)
Substance CAS EC Specific exemption on intermediate No No use or other specification Bis(pentabromophenyl 1163- 214- 1. For the purposes of this entry, )ether 19-5 604-9 point (b) of Article 4(1) shall apply (decabromodiphenyl to concentrations of decaBDE ether; decaBDE) equal to or below 1000 mg/kg (0,1 % by weight) when it occurs in substances, mixtures, articles or as constituents of the flame- retarded parts of articles. 2. By way of derogation, the manufacturing, placing on the market and use of decaBDE shall be allowed: (a) in the production of an aircraft, for which type approval has been applied for before date of entry into force and has been received before December 2022, before 2 March 2027; (b) in the production of spare parts for either of the following: (i) an aircraft, for which type approval has been applied for before date of entry into force and has been received before December 2022, produced before 2 March 2027 until the end of the service life of those aircraft; (ii) motor vehicles within the scope of Directive 2007/46/EC, produced before... [the date of entry into force of this Regulation], either until 2036 or the end of the service life of those motor vehicles, whichever date comes earlier. 3. The specific exemptions for spare parts for use in motor vehicles referred to in paragraph 2(b)(ii) shall apply for the production and use of commercial decaBDE falling into one or more of the following categories: (i) powertrain and under-hood applications such as battery mass wires, battery interconnection wires, mobile air-conditioning (MAC) pipes, powertrains, exhaust manifold bushings, under-hood insulation, wiring and harness under hood (engine wiring, etc.), speed sensors, hoses, fan modules and knock sensors; (ii) fuel system applications such as fuel hoses, fuel tanks and fuel tanks under body; (iii) pyrotechnical devices and applications affected by pyrotechnical devices such as air bag ignition cables, seat covers/fabrics (only if airbag relevant) and airbags (front and side); (iv) suspension and interior applications such as trim components, acoustic material and seat belts. (v) reinforced plastics (instrument panels and interior trim); (vi) under the hood or dash (terminal/fuse blocks, higher- amperage wires and cable jacketing (spark plug wires)); (vii) electric and electronic equipment (battery cases and battery trays, engine control electrical connectors, components of radio disks, navigation satellite systems, global positioning systems and computer systems); (viii) fabric such as rear decks, upholstery, headliners, automobile seats, head rests, sun visors, trim panels, carpets. 3. The manufacturing of decaBDE and its use in the production and placing on the market of the following articles shall be allowed: (a) articles placed on the market before ... [the date of entry into force of this Regulation]; (b) aircraft produced in accordance with subparagraph 2(a); (c) spare parts of aircraft produced in accordance with subparagraph 2(b). (d) electrical and electronic equipment within the scope of Directive 2011/65/EU. 4. For the purpose of this entry ‘aircraft’ means one of the following: (a) a civil aircraft produced in accordance with a type certificate issued under Regulation (EU) No 216/2008 of the European Parliament and of the Council or with a design approval issued under the national regulations of a Contracting State to the International Civil Aviation Organisation (ICAO), or for which a certificate of airworthiness has been issued by an ICAO Contracting State under Annex 8 to the Convention on International Civil Aviation; (b) a military aircraft.
2018/08/10
Committee: ENVI
Amendment 53 #
Proposal for a regulation
Annex IV – table – row 4
Sum of the concentrations of tetrabromodiphenyl ether, pentabromodiphenyl ether, hexabromodiphenyl ether and heptabromodiphenyl ether: 10050 mg/kg
2018/08/10
Committee: ENVI
Amendment 55 #
Proposal for a regulation
Annex IV – table 1 – column 4 – row 10 – footnote 7
7 7 . The limit is calculated as PCDD and PCDF according to the following toxic equivalency factors (TEFs): PCDF TEF PCDD TEF 2,3,7,8-TeCDD P 1 1,2,3,7,8-PeCDFD 1 1,2,3,4,7,8-HxCDD TEF P0,1 1,2,3,6,7,8-HxCDD 0,1 1,2,3,7,8,9-HxCDD TEF 2,3,7,8-Te 0,1 1,2,3,4,6,7,8-HpCDD 0,01 OCDD 1 1,0,0003 2,3,7,8-PTeCDDF 1 1,0,1 1,2,3,7,8-PeCDF 0,03 2,3,4,7,8-HxPeCDDF 0,1 3 1,2,3,4,7,8-HxCDF 0,1 1,2,3,6,7,8-HxCDD F 0,1 1,2,3,7,8,9-HxCDD F 0,1 2,3,4,6,7,8-HxCDF 0,1 1,2,3,4,6,7,8-HpCDD F 0,01 OCDD 1,2,3,4,7,8,9-HpCDF 0,01 OCDF 0,0003 2,3,7,8-TeCDF PCB 0,1 1,2,3,7,8-PeCDFTEF PCB 77 0,03 2,3,4,7,8-PeCDF001 PCB 81 0,3 1,2,3,4,7,8-HxCDF0003 PCB 126 0,1 1,2,3,6,7,8-HxCDFPCB 169 0,1 1,2,3,7,8,9-HxCDF 0,1 2,3,4,6,7,8-HxCDF 0,1 1,2,3,4,6,7,8-HpCDF03 PCB 105 0,00003 PCB 114 0,00003 PCB 118 0,00003 PCB 123 0,00003 PCB 156 0,00003 PCB 157 0,01 1,2,3,4,7,8,9-HpCDF0003 PCB 167 0,01 OCDF 0003 PCB 189 0,00003
2018/08/10
Committee: ENVI
Amendment 56 #
Proposal for a regulation
Annex V – part 1 – table – row 4
1 R4 1 Recycling/reclamation of metals and metal compounds, under the following conditions: The operations are restricted to residues from iron- and steel- making processes such as dusts or sludges from gas treatment or mill scale or zinc-containing filter dusts from steelworks, dusts from gas cleaning systems of copper smelters and similar wastes and lead- containing leaching residues of the non- ferrous metal production. Waste containing PCBs is excluded. The operations are restricted to processes for the recovery of iron and iron alloys (blast furnace, shaft furnace and hearth furnace) and non-ferrous metals (Waelz rotary kiln process, bath melting processes using vertical or horizontal furnaces), provided the facilities meet as minimum requirements the emission limit values for PCDDs and PCDFs laid down in accordance with Directive 2010/75/EU of the European Parliament and of the Council of 24 November 2010 on industrial emissions, whether or not the processes are subject to that Directive and without prejudice to the other provisions of the Directive .deleted
2018/08/10
Committee: ENVI