BETA

6 Amendments of Fulvio MARTUSCIELLO related to 2017/0353(COD)

Amendment 143 #
Proposal for a regulation
Recital 11 a (new)
(11a) The identification and traceability of products is a necessary prerequisite for verifying whether the compliance requirements laid down by this Regulation are respected.
2018/05/24
Committee: IMCO
Amendment 144 #
Proposal for a regulation
Recital 11 b (new)
(11b) Economic operators must always be able to identify their suppliers and downstream operators to whom a particular product has been supplied. Products should therefore bear information enabling them, their manufacturer and, where applicable, their importer to be identified.
2018/05/24
Committee: IMCO
Amendment 145 #
Proposal for a regulation
Recital 11 c (new)
(11c) As the indication of the country of origin helps to identify the actual place of manufacture, and as such information can facilitate the task of the market surveillance authorities in identifying the actual place of manufacture, the indication of origin should be added to the basic traceability requirements concerning the name and address of the manufacturer.
2018/05/24
Committee: IMCO
Amendment 175 #
Proposal for a regulation
Article 1 – paragraph 2
It also provides a framework for the market surveillance and traceability of such products to ensure that those products fulfil requirements providing a high level of protection of public interests such as health and safety in general, health and safety in the workplace, the protection of consumers, information about the country of origin, protection of the environment and security.
2018/05/24
Committee: IMCO
Amendment 190 #
Proposal for a regulation
Article 3 – paragraph 1 – point 2 a (new)
(2a) ‘country of origin’ defined on the basis of the non-preferential origin rules set out in Articles 59 to 61 of Regulation (EEC) No 952/2013 of the European Parliament and of the Council of 9 October 2013 laying down the Union Customs Code;
2018/05/24
Committee: IMCO
Amendment 232 #
Proposal for a regulation
Article 4 a (new)
Article 4a Conditions for compliance A product may be made available on the market only if the following conditions are met: (a) the product shall be marked with an indication of the country of origin. Where the size or nature of the product does not allow that, the indication may be provided on the packaging or in a document accompanying the product; (b) if the country of origin referred to in Article 3(2) of this Regulation is a Member State of the Union, the indication of the country of origin may be related to the Union or to a particular Member State.
2018/05/24
Committee: IMCO