7 Amendments of Eva MAYDELL related to 2016/0084(COD)
Amendment 102 #
Proposal for a regulation
Recital 8 a (new)
Recital 8 a (new)
(8a) In order to facilitate the compliance of the phosphate fertilising products with the requirements of this Regulation and to boost innovation, it is necessary to provide sufficient funding to the relevant technologies, particularly to decadmiation, by means of the financial resources available under Horizon 2020 and other financial instruments. The Commission should annually inform the Council and the European Parliament on how much EU funding has been provided for decadmiation.
Amendment 203 #
Proposal for a regulation
Article 6 – paragraph 10
Article 6 – paragraph 10
Amendment 233 #
Proposal for a regulation
Article 8 – paragraph 10
Article 8 – paragraph 10
Amendment 573 #
Proposal for a regulation
Annex IV – part 2 – module A – point 2.2 – point b
Annex IV – part 2 – module A – point 2.2 – point b
Amendment 585 #
Proposal for a regulation
Annex IV – part 2 – Module A1 – point 4 – paragraph 1
Annex IV – part 2 – Module A1 – point 4 – paragraph 1
The cycles and test referred to under Headings 4.1-4.3 below shall be carried out on a representative sample of the product at least every 36 months on behalf of the manufacturer, in order to verify conformity with
Amendment 586 #
Proposal for a regulation
Annex IV – part 2 – Module A1 – point 4.3.5 a (new)
Annex IV – part 2 – Module A1 – point 4.3.5 a (new)
4.3.5a. The manufacturer shall keep the test reports together with the technical documentation.
Amendment 588 #
Proposal for a regulation
Annex IV – part 2 – Module A1 – point 4 a (new)
Annex IV – part 2 – Module A1 – point 4 a (new)
4a. Notified bodies' information and operational obligations 4a.1. Each notified body shall, without undue delay, inform its notifying authority and other bodies notified under this Regulation carrying out similar conformity assessment activities covering the same products of the following: (a) any case where the manufacturer has not complied with the 6-month period for performing the tests required under point 4; (b) any test results which demonstrate non-conformity with the detonation resistance requirement referred to in paragraph 5 under PFC 1(C)(I)(a)(i-ii)(A) in Annex I. 5a.2. In the case referred to in point 5a.1.(b) the notified body shall request the manufacture: (a) to take the necessary measures in accordance with Article 6(8); (b) to perform the relevant test every 3 months for a period of 1 year.