BETA

14 Amendments of Patrizia TOIA related to 2022/0365(COD)

Amendment 112 #
Proposal for a regulation
Recital 8
(8) In order to ensure that the emissions for both light and heavy duty vehicles are limited in real life, testing vehicles in real conditions of use with a minimum set of restrictions, boundaries and other driving requirements and not only in the laboratory is required, while so called "biased-driving" should be avoided.
2023/05/30
Committee: ITRE
Amendment 121 #
Proposal for a regulation
Recital 14
(14) Vehicles with traction batteries, including plugin hybrids and battery electric vehicles, contribute to the decarbonisation of the road transport sector and, when it comes to bidirectional charging, also to grid efficiency. In order to gain and increase consumer trust in such vehicles, they should be performant and durable. It is therefore important to require that traction batteries retain a good part of their initial capacity after many years of use. That is of particular importance to buyers of second hand electric vehicles to ensure that the vehicle will continue to perform as expected. Monitors of the battery state-of- health should therefore be required for all vehicles that use traction batteries. In addition minimum performance requirements for battery durability of passenger cars should be introduced, taking into account the UN Global Technical Regulation 2247. _________________ 47 United Nations Global Technical Regulation on In-vehicle Battery Durability for Electrified Vehicles, UN GTR 22
2023/05/30
Committee: ITRE
Amendment 160 #
Proposal for a regulation
Article 3 – paragraph 2 – point 42
(42) ‘real driving emissions’ or ‘RDE’ means the emissions of a vehicle under normal driving conditions and maximum one of the extended conditions at the same time as specified in Tables 1 and 2 of Annex III;
2023/05/30
Committee: ITRE
Amendment 181 #
Proposal for a regulation
Article 4 – paragraph 1
1. Manufacturers shall ensure that the new vehicles they manufacture, which are sold, registered or put into service in the Union, are type approved in accordance with this Regulation. MAs from the specific application dates of this Regulation, manufacturers shall ensure that the new components or separate technical units, including engines, traction batteries, brake emission systems and replacement pollution control systems requiring type- approval which they manufacture and which are sold or put into service in the Union are type approved in accordance with this Regulation.
2023/05/30
Committee: ITRE
Amendment 185 #
Proposal for a regulation
Article 4 – paragraph 3 – subparagraph 1
When verifying compliance with the exhaust emission limits, where the testing is performed in one of the extended driving conditions, the emissions shall be divided by the extended driving divider set out in Annex III.
2023/05/30
Committee: ITRE
Amendment 211 #
Proposal for a regulation
Article 5 – paragraph 3
3. Manufacturers may designate vehicles as “Euro 7A vehicle” where those vehicles are equipped with adaptive control functions. The use of adaptive control functions shall be demonstrated to the type-approval authorities during type- approval and verified during the lifetime of the vehicle as set out in table 1, Annex IV.deleted
2023/05/30
Committee: ITRE
Amendment 212 #
Proposal for a regulation
Article 5 – paragraph 4
4. Manufacturers may designate vehicles as “Euro 7G vehicle” where those vehicles are equipped with internal combustion engines with geofencing technologies. The manufacturer shall install a driver warning system on those vehicles to inform the user when the traction batteries are nearly empty and to stop the vehicle if not charged within 5 km from the first warning while on zero- emission mode. The application of such geofencing technologies may be verified during the lifetime of the vehicle.deleted
2023/05/30
Committee: ITRE
Amendment 215 #
Proposal for a regulation
Article 5 – paragraph 5
5. Manufacturers may construct vehicles combining two or more of the characteristics referred to in paragraphs 1, 2 or 3 and designate them using a combination of symbols and letters such as “Euro 7+A”, “Euro 7+G”, “Euro 7+AG” or “Euro 7AG” vehicles.deleted
2023/05/30
Committee: ITRE
Amendment 252 #
Proposal for a regulation
Article 10 – paragraph 3
3. With effect from … [OP please insert the date = the date of entry into force of this Regulation]the publication of the implementing or delegated act, where a manufacturer so requests, the national approval authorities shall not refuse to grant EU emission type-approval or national emission type-approval for a new type of vehicle or engine, or prohibit the registration, sale or entry into service of a new vehicle complying with this regulation.
2023/05/30
Committee: ITRE
Amendment 260 #
Proposal for a regulation
Article 10 – paragraph 4
4. With effect from 1 July 2025, national authorities shall, in the case of new M1, N1 vehicles which do not comply with this Regulation consider certificates of conformity to be no longer valid for the purposes of registration and shall, on grounds relating to CO2 and pollutant emissions, fuel and energy consumption or battery durability, prohibit the registration, sale or entry into service of such vehicles.
2023/05/30
Committee: ITRE
Amendment 263 #
Proposal for a regulation
Article 10 – paragraph 4 a (new)
4a. With effect 48 months after entry into force of this Regulation, national authorities shall, in the case of new N1 vehicles which do not comply with this Regulation consider certificates of conformity to be no longer valid for the purposes of registration and shall, on grounds relating to CO2 and pollutant emissions, fuel and electric energy consumption or battery durability, prohibit the registration, sale or entry into service of such vehicles.
2023/05/30
Committee: ITRE
Amendment 279 #
Proposal for a regulation
Article 10 – paragraph 8
8. The Commission shall adopt implementing acts laying down the administrative and technical elements required for performing tests, checks and inspections for the purposes of verifying compliance with paragraph 1, as well as the technical elements required for market surveillance checks under paragraph 2. Those implementing acts shall be adopted in accordance with the examination procedure referred to in Article 17(2) and shall enter into force at least [3] years before the applicable dates in Article 10 (4) and (5).
2023/05/30
Committee: ITRE
Amendment 285 #
Proposal for a regulation
Article 11 – paragraph 1
1. With effect from 1 July 2025, the sale or installation of a system, component or separate technical unit intended to be fitted on an M1, N1 vehicle approved under this Regulation, shall be prohibited if the system, component and separate technical unit is not of type approved in compliance with this Regulation.
2023/05/30
Committee: ITRE
Amendment 286 #
Proposal for a regulation
Article 11 – paragraph 1 a (new)
1a. With effect from 48 months after entry into force of this Regulation, the sale or installation of a system, component or separate technical unit intended to be fitted on an N1 vehicle approved under this Regulation, shall be prohibited if the system, component and, separate technical unit is not of type approved in compliance with this Regulation.
2023/05/30
Committee: ITRE